Maintenance and adjustment
33
OPERATING MANUAL - Z587 BALER
zzz
NOTICE
Fig. 30. Chain tensioning on the baler right-hand side.
Adjustment of the chain and bar conveyor tensioning
Adjust the tensioning springs of the main conveyor on
both sides of the baler.
NOTICE
•
Open the left/right-hand side guard panel.
•
Loosen the lock nut on the nut 1.
•
Operate the nut 1 to adjust the chain tension.
•
Once the correct tension is set, secure the nut 1.
The tension of the left and right-hand springs must be
identical.
NOTICE
The distance "A" (from the bottom washer and the console) shall be
225 mm.
Fig. 31. Adjustment of the chain and bar conveyor tensioning.
5.4. ADJUSTING THE DRIVE CLAW CLUTCH OF THE
CHAIN AND BAR CONVEYOR
Check and adjust (as necessary) the alignment of the claw clutch
to keep a clearance of 5 mm between the teeth faces (with the clutch
disengaged).
Do this by turning the bolt 1, located at the claw clutch engagement
lever on the baler right-hand side.
Adjust when the baler hydraulic system pressure is 40 bar
minimum.
Fig. 32. Adjusting the claw clutch.
