Operating the machine
21
OPERATING MANUAL - Z587 BALER
Fig. 10. Cut-off valve.
Do not move the machine with the pickup down and its wheels resting
on the ground.
3.2.4. CONNECTING THE LIGHTING SYSTEM
Connect the lighting system cables and check that all indicators and
lamps work properly.
Always use fuses of correct rating and do not replace the wiring or
plugs or sockets with non-genuine parts.
Keep the electrical connector protective caps in the tractor cab.
Replace them on the plugs when finished working with the machine.
3.2.5. CONNECTING THE CONTROL SYSTEM
The baler electrical system requires a 12 V power supply.
1. Install the control panel "SS" in the tractor cab in a location readily
visible to and within the reach of the operator.
2. Connect the power cable "PZ".
3. Connect the control cable "PS".
4. Check that the control panel "SS" powers on.
If the wiring is connected correctly, the control panel will light up and
initialize the data.
Fig. 11. Connecting the control system.
3.2.6. DECOUPLING THE DRIVE
Make sure that there are no bystanders, especially children, in the
storage area of the baler.
1. Park the machine for storage on a hard, flat and level ground.
Stop the tractor engine, remove the ignition key, and engage the
parking brake of the tractor.
2. Disconnect the electric power supply.
Closed
Open
