Commissioning
17
OPERATING MANUAL - Z587 BALER
2. COMMISSIONING
The commissioning of a new baler is done by the
dealership service representative or the manufacturer's
representative in witness of the operator/buyer of the
machine.
NOTICE
Before commissioning the baler, thoroughly read and
understand this Manual and pay special attention to
the Sections concerning the safety of the operator and
bystanders.
WARNING!
If there are any doubts about safety, contact your
dealership or the manufacturer.
NOTICE
Install the control panel in the tractor cab each time before you start
the baler.
2.1. COMMISSIONING THE BALER
Exercise extreme caution during commissioning.
The presence of persons who undergo training in the
machine working range increases the safety hazard.
WARNING!
The dealership service representative or the manufacturer's
representative in witness of the operator/buyer of the machine does the
following during commissioning:
1. Baler equipment inspection and functional testing:
•
Machine completeness and technical condition check
•
Lighting system and warning horn check
•
Hydraulic system check:
◊ Lifting and lowering of the pickups
◊ Lifting and lowering of the rear chamber
•
Pickup functional test
•
Wrapping system functional test:
◊ with the cord
◊ with the net (optional accessory)
•
Central lubrication functional test (optional accessory).
2. User training in proper operation of the baler:
•
Introduction to the pickup design and operating principle:
◊ Setting the attack angle of springs
◊ Engagement of the overload clutch
◊ Reinstalling the clutch after safety bolt shearing
◊ Complete clutch replacement
◊ Lubrication of the roller raceways.
•
Introduction to the cord wrapping system design and operating
principle:
◊ Operating principle
◊ Installing the cord
◊ Adjusting the wrap wind spacing and cord tension
◊ Bale compaction adjustment
◊ Cleaning the cord feeder.
•
Introduction to the net wrapping system design and operating
principle (optional accessory):
◊ Operating principle
◊ Installing the net
◊ Adjusting the number of winds
◊ Adjusting the cutter frame spring tension.
•
Introduction to the central lubrication system design and
operating principle (optional accessory):
◊ Operating principle
◊ Pump output adjustment.
