29
OPERATING MANUAL - Z587 BALER
Finishing the work / Maintenance and adjustment
4. FINISHING THE WORK
•
When your work is done, disconnect the control panel and secure
it against water.
•
Park the machine on a hard, flat, level ground. Disconnect the
hydraulic power source and the electric power supply.
•
Rest the baler on its support foot.
•
Detach the tow bar hitch-ring from the tractor transport hitch.
•
Decouple the PTO drive shaft and place on a rest. Install the
protective caps on the PTO and PIC ends.
•
Do not decouple the tractor from the baler with a bale in the
chamber.
•
Clean and thoroughly inspect the machine, especially the paint
coating. If the paint coating needs touching up, use the paint repair
kit supplied by the manufacturer.
•
Secure all rubber parts, e.g. hydraulic hoses and tyres from direct
exposure to sunlight.
•
Keep the baler in prolonged storage in a dry sheltered room or
under a canopy which protects the machine from weather.
5. MAINTENANCE AND ADjUSTMENT
Before attempting any maintenance, follow the safety
rules in Section 1.5. "General Safety Standards".
WARNING!
Do all maintenance and adjustment tasks with the machine parked
and all of its moving components stopped.
If the baler is coupled with the tractor, stop the tractor engine, remove
the ignition key and engage the parking brake of the tractor. Remember
to turn off the control panel.
If you need to do maintenance with the baling chamber
open, secure the lift cylinders.
WARNING!
Fig. 23. Lift cylinder safety locks.
