Purpose
M=LIGHT Control
44
/
88
05.02.2019
8LE-D23_BA_E.docm
5.1
Purpose
The software is used for control and parameterization of the M=LIGHT LED. The settings are
stored in the M=LIGHT LED and are retained when the M=LIGHT LED is disconnected from the
power supply or the CAN bus line.
The following settings are stored:
Operating mode saved settings
Steady Light
Power (%)
Flash light:
Power (%)
Sync Input
Pulse periode (µs)
Pulse width (µs)
Pulse delay (µs)
Pulse Count
Invert Input
5.2
Install M=LIGHT Control software
5.2.1 System Prerequisites
I
PC with USB or network connection.
I
Up-to-date Windows operating system.
I
CAN-Bus Interface Adapter for USB connection of network connection (Section 3.4.1, Page 15
and Section 4.5, Page 30).
5.2.2 Installation Process
Connect the data carrier supplied with the M=LIGHT LED to the PC.
Open the data medium in Windows Explorer.
Run SetupForCustomers.exe.
Select a language.
The installation routine guides you through the installation of the software
MESSRING M=LIGHT
Control
and subsequently through the installation of the driver for the CAN-bus interface.
