5.9
Check AP433i & 433is LED Activity
When AP433i & 433is first connects to the controller (and any time the access
point is rebooted), the AP initializes and is then programmed by the controller.
When the AP first powers up, all LEDs are green
Figure 26, AP433i & 433is LEDs
After the AP433i & 433is is connected, check the status of the LEDs. The
functions of the LEDs are described below
5.9.1
AP433i & 433is LED Description
LED
Functions
Troubleshooting
Power
•
Off: No power
•
Green: Presence of power
Activity
•
Off: No power
•
Green : Booting stage 1
•
Blinking green and off: Booting
stage 2.
•
Blinking green and white:
Discovering the controller.
•
Blinking green and blue:
Downloading a configuration from
the controller
•
Blinking blue and off: AP is online
and enabled, working state
•
Blinking red and yellow: Failure;
consult controller for alarm state
•
If the status LED is blinking red
and yellow, there is an alarm on
the AP.
•
Determine what the alarm is by
clicking Monitor >
Dashboard >Alarms and looking
at the AP alarms.
•
You can also use the CLI
commands show alarm and show
log.
5.9.2
Change LED Appearance
If you want to change the appearance of the LEDS, follow these steps:
•
From the controller, click Configuration > Devices > AP, and then select
the AP.
•
Select one of these settings for the LED Mode setting:
o
Normal: LEDs are as described above
o
Blink: Sets all LEDs flashing; this is useful to locate an AP
o
Dark: Turns off all LEDs