6
Installing OAP433e
This chapter describes how to physically install an OAP433e, which is supported
on System Director Versions 6.0 SR2 and later. It contains the following sections:
•
Unpacking the OAP433e
•
Installation Requirements
•
Assembling the Waterproof Ethernet Connector
•
Installing the Access Point
•
Where to Go From Here
•
Unpacking the OAP433e
Note
Please use the OAP433 series only with Listed ITE or equivalently-rated
equipment.
6.1
Unpacking the OAP433e
Confirm that the OAP433e shipping boxes contain the following items (see Figure
27, OAP433e outdoor access point (top & bottom)
•
OAP433e Outdoor Access Point
•
Water barrier for the Ethernet connection (when shipped, this is not
connected to the AP)
•
Wall/Pole Mount Hardware Kit for mounting OAP433e to a 2” to 3”
diameter steel pole or tube or as part of a radio or tower structure (3
pieces)
•
Screws and bolts for assembling the mounting bracket
•
Drywall screws (for wall-mounted installation)
•
Ground wire
Figure 27, OAP433e outdoor access point (top & bottom)
6.2
Installation Requirements
In addition to the hardware supplied by Meru Networks, you need the following
required accessories.
•
Antennas (sold separately)