Merging VCube, User Manual

Page: 171 / 291

Remote Control : Synchronizing VCube to a Sony 9-pin Chase Synchronizer Page 171
Synchronizing VCube to a Sony 9-pin Chase Synchronizer
VCube can chase a Sony 9-pin Chase Synchronizer.
1. In the Format & Sync Tab : Synchronization section configure as below:
Toggle Chase Unchecked
Sony 9 Pin Remote Control Checked
2. The RS-422 configuration switch must be set to From Controller if you use the RS-422 port. This port is
named COM3 in the Settings dialog. This port is named COM2 in the Settings dialog for early VCubes using an
ASUS motherboard. The RS-232 port is named COM1 .
3. In this configuration both Audio and Video references must be used. Audio should ideally be referenced to
the same source of Video syncs as the Video.
Sony P2 Protocol over IP
Pyramix and VCube can now be synchronized over an ethernet LAN.
VCube does not require any configuration. No special Settings are needed (e.g. no Port Name field)
Just turn on Sony 9 Pin Remote Control . It only works with VCube as the “machine”
Please see the Pyramix User Manual for all relevant details
Formats & Sync Tab - Synchronization section