FUEL INJECTION SYSTEM TROUBLESHOOTING
SERVICE MANUAL NUMBER 23
Page 5D-14
90-861326--1 MARCH 1999
Lack of Power, Sluggish or Spongy Symptom (Continued)
6
1. Check for proper fuel pressure while
the condition exists.
•
Refer to Table A-4 in “General Sys-
tem Diagnostics” section.
2. If a problem is found, repair as
necessary.
Was a problem found?
-
Go to OBD
System
Check
Go to Step 7
7
1. Check for injector driver CKT’s 467
or 468 for an open.
2. If a problem is found, repair as
necessary.
Was a problem found?
-
Go to OBD
System
Check
Go to Step 8
8
1. Check for proper operation of
Ignition Control (IC) circuit nd the
Knock Sensor (KS) circuit.
2. If a problem is found, repair as
necessary.
Was a problem found?
-
Go to OBD
System
Check
Go to Step 9
9
1. Check for proper ignition voltage
output.
•
Refer to Table A-7 in “General Sys-
tem Diagnostics” section.
2. If a problem is found, repair as
necessary.
Was a problem found?
-
Go to OBD
System
Check
Go to Step 10
10
1. Remove spark plugs, check for wet
plugs, cracks, wear, improper gap,
burned electrodes or heavy
deposits.
•
Refer to “Distributor Ignition Sys-
tem” in “Description and System Op-
eration” section.
NOTE: If park plugs are gas or oil fouled,
the cause of the fouling must be deter-
mined before replacing the spark plugs.
2. If a problem is found, repair as
necessary.
Was a problem found?
-
Go to OBD
System
Check
Go to Step 11
11
1. Check ignition coil for cracks or
carbon tracking.
2. If a problem is found, repair as
necessary.
Was a problem found?
-
Go to OBD
System
Check
Go to Step 12
Downloaded from
https://needmanual.com/
Index
