SEAWATER COOLED MODELS
SERVICE MANUAL NUMBER 23
Page 6A-16
90-861326--1 MARCH 1999
Reassembly
1. Apply a thin coat of Loctite Type 27131 to outside diameter of two new bearing housing
rear seals; then install seals in housing with seal lips facing impeller end. Press first seal
in until it contacts and second seal until flush with housing.
72660
a
b
a -
Outer (Water) Seal
b -
Face of Housing
IMPORTANT: It is recommended that Shell Alvania No. 2 Grease be used when
packing seal and bearings in the following steps. If Shell Alvania No. 2 Grease is not
available, it is permissible to use Quicksilver 2-4-C With Teflon. However, Quicksilver
2-4-C Marine Lubricant With Teflon is not recommended for applications where
continuous high speed heavy-duty operation will be encountered.
2. Pack cavity between seals with Shell Alvania No. 2 Grease or substitute.
3. Using an arbor press and suitable tool, press ball bearings onto shaft until they seat.
Press on inner race of bearing only.
72663
a
a -
Bearings
Downloaded from
https://needmanual.com/
Index
