Section 5 - Maintenance
90-8M0050539
eng
MAY 2011
Page 79
Engine Oil—350/377 MAG ECT and SeaCore 350/377 MAG ECT
Checking
NOTICE
Discharge of oil, coolant, or other engine/drive fluids into the environment is restricted by law. Use caution not to spill oil, coolant,
or other fluids into the environment when using or servicing your boat. Be aware of the local restrictions governing the disposal
or recycling of waste, and contain and dispose of fluids as required.
1. Stop the engine. Allow approximately five minutes for the oil to drain into the oil pan. The boat must be at rest in the water.
2. Remove the dipstick. Wipe clean and reinstall fully into the dipstick tube. Wait 60 seconds to allow trapped air to vent.
NOTE: Ensure that dipstick is installed with oil level indication marks facing the rear of the engine (flywheel end).
33200
Dipstick
IMPORTANT: Add the specified engine oil to bring the level up to, but not over, the full or OK range mark on the dipstick.
3. Remove the dipstick and observe the oil level. Oil level must be between full or OK range and add. Reinstall dipstick into
dipstick tube.
Filling
IMPORTANT: Do not overfill the engine with oil.
IMPORTANT: Always use the dipstick to determine the exact quantity of oil or fluid required.
1. Remove oil fill cap.
33210
Oil fill cap
2. Add the specified engine oil to bring the level up to, but not over, the full or OK range mark on the dipstick. Recheck oil level.
3. Replace the fill cap.
Summary of Contents for MerCruiser Axius SeaCore 350 MAG
Page 28: ...Section 1 Warranty Notes Page 20 90 8M0050539 eng MAY 2011...
Page 56: ...Section 2 Getting to Know Your Power Package Notes Page 48 90 8M0050539 eng MAY 2011...
Page 70: ...Section 3 On the Water Notes Page 62 90 8M0050539 eng MAY 2011...
Page 162: ...Section 7 Troubleshooting Notes Page 154 90 8M0050539 eng MAY 2011...
