Mercury MerCruiser Axius SeaCore 350 MAG, Manual

Page: 151 / 170

Section 6 - Storage
90-8M0050539
eng
MAY 2011 Page 143
2. Rotate the blue handle counterclockwise until it stops (approximately two turns). The red on the handle shaft indicates that
the drain system is open. Do not overtighten the handle, as this action will create new threads.
a - Blue handle
3. Visually verify that water is draining. If water does not drain, remove the blue drain plug from the distribution housing and
drain manually.
a - Drain location ‑ orange or red
b - Blue drain plug
4. Allow the system to drain for a minimum of five minutes. We recommend leaving the plugs out while transporting the boat or
performing other maintenance to ensure that all water is drained.
5. Close the drain system by rotating the blue handle clockwise until it stops or installing the blue drain plug. The handle is fully
seated when no red is visible. Do not overtighten handle, as this action will create new threads.
Three‑Point Manual Drain System
Boat in the Water
NOTE: Use this procedure if your engine is not equipped with an air‑actuated single‑point drain system or if the air‑actuated single
point drain system fails.
1. Close the seacock (if equipped) or remove and plug the water inlet hose.
2. Remove the blue drain plug from the distribution housing (lower front, port side).
a - Blue drain plug
a
6141
a
b
6137
6138
a