Mercury MerCruiser Axius SeaCore 350 MAG, Manual

Page: 168 / 170

Section 9 - Checklists
Page 160 90-8M0050539
eng
MAY 2011
Predelivery Inspection (PDI)
IMPORTANT: This checklist is for packages that are not equipped with Axius. For engine packages equipped with Axius, use the
Axius‑specific checklist, which appears in Section 5 of the Axius Operation Manual.
Perform these tasks before the Customer Delivery Inspection (CDI).
N/A Check/
Adjust Item
⃞ ⃞ Service bulletin updates or repairs completed
⃞ Drain plug installed and drain valves closed
⃞ ⃞ Seawater inlet valve open
⃞ Engine mounts tight
⃞ ⃞ Engine alignment
⃞ ⃞ Drive unit fasteners tightened to specifications
⃞ ⃞ Power trim cylinders fasteners tight
⃞ Battery of proper rating, fully charged, secured, with protective covers in place
⃞ All electrical connections tight
⃞ Exhaust system hose clamps tight
⃞ All fuel connections tight
⃞ Correct propeller selected, installed, and tightened to specifications
⃞ Throttle, shift and steering system fasteners tightened to specifications
⃞ ⃞ Test OBDM warning system and MIL (light) operation (EC models only)
⃞ Steering operation throughout range
⃞ Throttle plates open and close completely
⃞ Crankcase oil level
⃞ ⃞ Power trim oil level
⃞ ⃞ Sterndrive unit oil level
⃞ ⃞ Power steering fluid level
⃞ ⃞ Closed Cooling fluid level
⃞ ⃞ Transmission fluid level
⃞ ⃞ V‑engines: serpentine belt tension
⃞ ⃞ Alternator belt tension (3.0L)
⃞ ⃞ Power steering pump belt tension (3.0L)
⃞ ⃞ SmartCraft gauges calibrated, if equipped
⃞ ⃞ Warning system operation
⃞ ⃞ Trim limit switch operation