Section 5 - Maintenance
90-8M0050539
eng
MAY 2011
Page 75
Task Interval
Maintenance to Be Performed
Every two months or 50
hours of operation
•
Remove the propeller and lubricate the propeller shaft and torque the nut. (If operating only in
freshwater, you can extend the interval to every four months.)
•
If operating in saltwater, brackish water, or polluted water, apply Corrosion Guard to the power
package.
•
Check the battery connections and the fluid level.
•
Ensure that the gauges and the wiring connections are secure. Clean the gauges. (If operating
in saltwater, reduce this interval to every 25 hours or 30 days, whichever occurs first.)
Scheduled Maintenance
NOTE: Only perform maintenance which applies to your particular power package.
Task Interval
Maintenance to Be Performed
After the initial 20‑hour
break‑in period
Change the engine oil and filter.
Every 50 hours or 2
months
(whichever occurs first)
All Bravo models: Lubricate the engine coupler (lubricate the engine coupler every 50 hours if
operated at idle for prolonged periods of time).
Every 100 hours or
annually
(whichever occurs first)
•
Touch‑up the paint on the power package.
•
Change the engine oil and filter.
•
Change the sterndrive gear lube.
•
If the condition of the spark plugs, spark plug wires, and the distributor cap and rotor was
satisfactory at the initial inspection (as listed in
Every 300 hours or 3 years
), inspect the
condition of these components. Replace as necessary.
•
On models with closed cooling, check the coolant level and antifreeze concentration for
adequate freeze protection. Correct if necessary. Refer to the
Specifications
section.
•
Tighten the connection of the gimbal ring to the steering shaft to specifications.
•
Replace the water‑separating fuel filter.
•
Check the steering system and the remote control for loose, missing, or damaged parts.
Lubricate the cables and the linkages.
•
Check the continuity circuit for loose or damaged connections. Test the MerCathode unit output
if equipped.
•
Clean the flame arrestor, IAC muffler, and the crankcase ventilation hoses. Inspect the PCV
valve, if equipped.
•
Inspect the condition and the tension of the belts.
•
Driveshaft extension models: Lubricate the driveshaft U‑joints, and tailstock input and output
bearings.
Every 150 hours or
annually
(whichever occurs first)
All Bravo models: Lubricate the engine coupler.
Summary of Contents for MerCruiser Axius SeaCore 350 MAG
Page 28: ...Section 1 Warranty Notes Page 20 90 8M0050539 eng MAY 2011...
Page 56: ...Section 2 Getting to Know Your Power Package Notes Page 48 90 8M0050539 eng MAY 2011...
Page 70: ...Section 3 On the Water Notes Page 62 90 8M0050539 eng MAY 2011...
Page 162: ...Section 7 Troubleshooting Notes Page 154 90 8M0050539 eng MAY 2011...
