Mercury 92-858058K01, Manual

Page: 102 / 150

Section 5 - Maintenance
Page 94 90-879172181
eng
FEBRUARY 2011
Changing
You do not need to change the steering actuator and trim system oil and filter unless they become contaminated with water or
debris. A switch in the high‑pressure filter system will set a VesselView fault code to alert the operator when the hydraulic oil and
filter require changing.
Change the hydraulic oil and filter whenever the VesselView fault code is displayed.
VesselView Fault Code Reason Task
"Filter Dirty Fault" or "Service
Steering Filter"
Hydraulic oil filter is dirty
Change the oil and filter as soon as reasonably
possible, if not immediately
Contact your local Authorized Cummins MerCruiser Diesel Repair Facility for additional information.
High-pressure filter system
a - Filter head with switch (switch not shown)
b - Filter housing with filter element
Transmission Oil (Fluid) and Filter
Checking
If the drive is equipped with a drive cover, you can check the transmission oil (fluid) level through the access cover or with the
drive cover removed, if equipped.
1. If equipped with a drive cover, lift the front of the access cover from the drive cover or remove the drive cover, to access the
transmission dipstick.
a - Access cover
b - Molded clip
c - Indented‑edge
a
b
37306
a
c
b
39506