Mercury 92-858058K01, Manual

Page: 101 / 150

Section 5 - Maintenance
90-879172181
eng
FEBRUARY 2011 Page 93
6. If the level is correct, insert the cap and dipstick into the neck of the reservoir. Push down and turn the reservoir cap in the
close direction.
a - Cap and dipstick
b - Open direction
c - Close direction
Filling
1. Using a clean, lint‑free cloth, wipe the dirt and debris away from the cap and exterior of the steering actuator and trim fluid
reservoir.
NOTE: The direction to rotate the cap to open or close is imprinted on the top of the cap.
2. Remove the cap and dipstick. Push down and turn the reservoir cap and dipstick about 1/3 turn in the open direction.
a - Reservoir cap and dipstick
b - Open direction
c - Close direction
IMPORTANT: Always use the dipstick to determine the exact quantity of oil required.
3. Fill the hydraulic reservoir with the specified oil to bring the level up to the full‑cold mark. Do not overfill.
a - Cap and dipstick
b - Full‑cold mark
c - Low‑cold mark
d - Add
Tube Ref No. Description Where Used Part No.
138
Synthetic Power Steering
Fluid SAE 0W-30
Hydraulic system 92-858076K01
4. Insert the cap and dipstick into the neck of the reservoir. Push down and turn the reservoir cap in the close direction.
b
c
a
40235
b
c
a
40235
b
c
a
40243
d