Mercury 92-858058K01, Manual

Page: 99 / 150

Section 5 - Maintenance
90-879172181
eng
FEBRUARY 2011 Page 91
7. Continue to pump gear lube into the drive until the gear lube appears in the gear lube monitor at the "COLD FILL LEVEL"
line. Do not overfill.
41468
"COLD FILL LEVEL" line
Drive Model
Fluid Capacity (includes
the drive and the gear lube
monitor)
Fluid Type Fluid Part Number
Zeus 5‑1/4 L (5‑1/2 US qt)
High Performance Gear
Lube
92‑858064K01 1 L (1 US qt)
92‑858065Q01 9.5 L (2.5 US gal)
8. Remove the gear lube pump and quickly reinstall the gear case fill and drain screw and washer.
Description Nm lb‑in. lb‑ft
Gear case fill and drain screw 6.7 60 –
9. Fill the gear lube monitor to the "COLD FILL LEVEL" line, if the level is low. Refer to
Filling
.
10. Ensure that the rubber gasket is inside the cap for the gear lube monitor and install the cap. Do not overtighten.
11. Install the drive propellers. Refer to
Propellers
.
12. Check the gear lube level at the gear lube monitor after the first use. Refer to
Checking
.
NOTE: After the drive has been operated and the gear lube is hot, the fluid will expand and may reach the "MAX OPERATING
LEVEL" line (hot full line).
41467
"MAX OPERATING LEVEL" line (hot full line).
Steering Actuator and Trim—Hydraulic Oil
The steering actuator and trim system use a common hydraulic pump, filtering system, and hydraulic oil storage reservoir for
lubrication and pressure. The pump, filter, and storage system are the same on all models. For specific procedures, refer to
Checking, Filling,
and
Changing
.