Mercury 15 EFI FourStroke, Service Manual

Page: 245 / 406

9. Remove the port clamp bracket from the tilt tube, feeding the power tilt pump wires out through the hole in the bracket.
a - Cap
b - Locknut
c - P‑clip
d - Cable ties (2)
e - Tilt lock pin, locknut, and washer
f - Lower pivot pin screw (M8 x 20) and washer
g - Ground cable screw on power tilt unit
h - Port clamp bracket
10. Inspect the tilt lock pin, lower pivot pin bushing, and anode.
a - Ground cable
b - Screw (M6 x 16)
c - Anode
d - Lower pivot pin bushing
e - Tilt lock pin
Port Bracket Installation
1. Install the lower pivot pin bushing.
2. Install the tilt lock pin. Tighten the locknut to the specified torque.
3. Install the anode and ground cable. Tighten the anode screw to the specified torque.
a - Ground cable
b - Screw (M6 x 16)
c - Anode
d - Lower pivot pin bushing
e - Tilt lock pin
Description Nm lb‑in. lb‑ft
Anode screw (M6 x 16) 6.0 53.1 –
Tilt lock pin locknut 13 115 –
4. Install the clamp bracket partially onto the tilt tube.
5. Route and secure the power tilt pump wires:
a. Feed the harness through the hole in the bracket.
b. Secure the power tilt pump wires to the inside of the port clamp bracket with two cable ties.
c. Secure the power tilt pump wires to the outside of the port clamp bracket with a P‑clip.
a
b
c
d
e
d
f
g
h
63659
a
c
b d
e
63489
a
c
b d
e
63489
Clamp/Swivel Bracket and Driveshaft Housing
Page 5A-26 © 2018 Mercury Marine 90-8M0125265 eng NOVEMBER 2017