Mercury 15 EFI FourStroke, Service Manual

Page: 255 / 406

a. Install the copilot threaded rod into the swivel bracket.
b. Install one disc and washer (item c, shown following) onto the threaded rod.
c. Attach the plate to the steering arm with two screws and washers.
d. Install a disc, handle, washer, and locknut onto the threaded rod. Tighten the locknut to the specified torque.
a - Threaded rod
b - Disc
c - Washer
d - Plate
e - Screws and washers
f - Disc
g - Copilot handle
h - Washer
i - Locknut
Description Nm lb‑in. lb‑ft
Copilot locknut 11.0 97.3 –
4. Lubricate the steering arm O‑ring with 2‑4‑C with PTFE.
5. Install the O‑ring onto the steering arm shaft.
a - Swivel bracket
b - O‑ring
c - Steering arm shaft
Tube Ref No. Description Where Used Part No.
95
2-4-C with PTFE Steering arm O-ring 92-802859A 1
6. Attach the outboard to the swivel bracket. Refer to
Powerhead/Midsection Assembly Separation
.
IMPORTANT: Ensure that the upper mount locknuts are tightened to the specified torque.
Description Nm lb‑in. lb‑ft
Upper mount locknut 27.0 – 19.9
a
b
c
d
e
f
g
h
i
63351
35144
c
b
a
Clamp/Swivel Bracket and Driveshaft Housing
Page 5A-36 © 2018 Mercury Marine 90-8M0125265 eng NOVEMBER 2017