Mercedes-Benz GLC 200 4MATIC, Owner'S Manual

Page: 71 / 601

If the centre seat backrest is not engaged and
locked in place, the red lock verification indicator
will be visible.
&
WARNING Risk of injury or death if the
permissible gross mass of the child and
child restraint system together is excee-
ded.
Too much load may be placed on the ISOFIX
or i‑Size child restraint systems and the child
may not be restrained correctly in the event of
an accident, for example.
#
If the child is secured in an ISOFIX or i-
Size child restraint system with integra-
ted seat belts, the total mass of the child
and child restraint system must not
exceed 33 kg.
Always comply with the information about the
mass of the child:
R
in the manufacturer's installation and operat-
ing instructions for the child restraint system
used
R
on a label on the child restraint system, if
present
Regularly check that the permissible gross mass
of the child and child restraint system is still com-
plied with.
When fitting a child restraint system, observe the
following:
O
Always observe the correct use of the seats
and consider their suitability for attaching a
child restraint system.
ISOFIX child seat anchor (
/
page 66)
or
i‑Size child seat anchor (
/
page 67)
O
Always comply with the manufacturer's
installation and operating instructions for the
child restraint system used.
O
Make sure that the child's feet do not touch
the front seat. If necessary, move the front
seat slightly forwards.
®
When fitting an ISOFIX child restraint sys-
tem, also observe the following:
O
When using a baby car seat in weight group
0/0+ and a rearward-facing child restraint
system in weight group 1 on a rear seat:
adjust the front seat so that the seat does
not touch the child restraint system.
O
When using a forward-facing child restraint
system in weight group 1: remove the head
restraint from the respective seat, if possible.
In addition, the backrest of the child restraint
system must lie as flat as possible against
the backrest of the vehicle seat.
After the child restraint system has been
removed, replace the head restraint immedi-
ately and adjust all head restraints correctly.
O
If the head restraint of the child seat cannot
be fully extended when it is installed in the
vehicle; this will result in restrictions on the
maximum size setting for child restraint sys-
tems in weight group 2 or 3.
Contact with the roof when the head
restraint is fully extended and locked in place
will not result in any restrictions on use.
68 Occupant safety