Mercedes-Benz E-Class 2010, Owner'S Manual

Page: 46 / 333

belt. If the vehicle is stationary and a door is
opened, the 7 seat belt warning lamp
goes out and the warning tone ceases.
For certain countries only: regardless of
whether the driver or the front passenger
have fastened their seat belts, the 7 seat
belt warning lamp lights up for 6 seconds
after the engine is started. It then goes out
once the driver and the front passenger have
fastened their seat belts.
i
For more information on the 7 seat
belt warning lamp, see "Indicator and warn-
ing lamps in the instrument cluster, seat
belt" (
Y
page 236).
Rear seat belt status indicator
The rear-compartment seat belt status indi-
cator tells you if the rear passengers have
their seat belts fastened.
The rear-compartment seat belt status indi-
cator indicates the rear seat on which the belt
is fastened.
The rear-compartment seat belt status indi-
cator appears in the multifunction display for
around 30 seconds if:
R
you drive off and reach a speed of approx-
imately 10 km/h.
R
the rear passengers fasten or unfasten
their seat belts while the vehicle is in
motion.
R
someone gets in or out of the vehicle and
the vehicle drives off again.
Example: the passenger in the right rear seat has
their seat belt fastened
You can also cancel the rear seat belt status
indicator immediately (
Y
page 210).
i
The status indicator for the rear-compart-
ment seat belts is only available for certain
countries.
Belt tensioners, belt force limiters
The seat belts are fitted with belt tensioners.
!
If the front-passenger seat is not occu-
pied, do not engage the seat belt tongue in
the buckle on the front-passenger seat.
Otherwise, the belt tensioner could be trig-
gered in the event of an accident.
The belt tensioners tighten the seat belts in
an accident, pulling them close against the
body.
Belt tensioners do not correct incorrect seat
positions or incorrectly fastened seat belts.
Belt tensioners do not pull vehicle occupants
back towards the backrest.
If the seat belt is also fitted with a belt force
limiter and this is triggered, the force exerted
by the seat belt on the vehicle occupant is
reduced.
The front belt force limiters are synchronised
with the front airbags, which take on a part of
the deceleration force. Thus, the force exer-
ted on the occupant is distributed over a
greater area.
The belt tensioners can only be activated
when:
R
the ignition is switched on
R
the restraint systems are operational; see
"SRS warning lamp" (
Y
page 33)
R
the belt tongue is engaged in the buckle on
each of the three-point seat belts in the
front
The belt tensioners on the seats in the rear
compartment are triggered independently of
the lock status of the seat belts.
The belt tensioners are triggered depending
on the type and severity of an accident:
R
in the event of a head-on or rear-end colli-
sion if the vehicle decelerates or acceler-
Occupant safety
43
Safety
BA 207 ECE ÄJ 2010/1a; 1; 2, en-GB
mkalafa Version: 3.0.2.11
2010-01-26T13:03:22+01:00 - Seite 43
Z