tyres is set correctly for the respective
operating conditions.
X
Observe the notes in the section on tyre
pressures (
Y
page 299).
G
Risk of accident
The tyre pressure loss warning system can
only give reliable warnings if you have set the
correct tyre pressure.
If an incorrect tyre pressure is set, these
incorrect values will be monitored.
A tyre with insufficient pressure results in
vehicle instability when driving, thus increas-
ing the risk of an accident.
X
Make sure that the key is in posi-
tion 2(
Y
page 135) in the ignition lock.
In the multifunction display you will see the
standard display (
Y
page 197).
X
Press the
=
or
;
button to select the
Service
menu.
X
Press the
9
or
:
button to select
Tyre pressure
.
X
Press the
a
button.
The multifunction display shows the mes-
sage:
Run Flat Indicator active Restart
with OK
If you wish to confirm the restart:
X
Press the
a
button.
The multifunction display shows the mes-
sage:
Tyre press. now OK?
X
Press
9
or
:
to select
Yes
.
X
Press the
a
button.
The multifunction display shows the mes-
sage:
Run Flat Indicator restarted
After a teach-in period, the tyre pressure
loss warning system will monitor the set
tyre pressures of all four tyres.
If you wish to cancel the restart:
X
Press the
%
button.
or
X
If the
Tyre press. now OK?
message
appears, use
9
or
:
to select
Can‐
cel
.
X
Press the
a
button.
The tyre pressure values stored at the last
restart will continue to be monitored.
Direction of rotation
Tyres with a specified direction of rotation
have additional benefits, e.g. if there is a risk
of aquaplaning. You will only gain these ben-
efits if the correct direction of rotation is
observed.
An arrow on the sidewall of the tyre indicates
its correct direction of rotation.
You may fit an emergency spare wheel/spare
wheel against the direction of rotation.
Observe the time restriction on use as well as
the speed limitation specified on the emer-
gency spare wheel/spare wheel.
Interchanging the wheels
G
Risk of accident
Interchange the front and rear wheels only if
they have the same dimensions: for example
size, offset, etc.
After every wheel interchange/change, have
the tightening torque checked at a qualified
specialist workshop that has the necessary
specialist knowledge and tools to carry out
the work required. Mercedes-Benz recom-
mends that you use a Mercedes-Benz Service
Centre for this purpose. In particular, work
relevant to safety or on safety-related sys-
tems must be carried out at a qualified spe-
cialist workshop.
The wheels could work loose if they are not
tightened to a torque of 130 Nm.
302
Interchanging the wheels
Tyr
es
and
whe
el
s
BA 207 ECE ÄJ 2010/1a; 1; 2, en-GB
mkalafa
Version: 3.0.2.11
2010-01-26T13:03:22+01:00 - Seite 302
Summary of Contents for E-Class 2010
