Problems with Night View Assist Plus
Problem
Possible causes/consequences and
M
Solutions
The picture quality of
Night View Assist Plus
has deteriorated.
The windshield wipers are smearing the windshield.
X
The windshield is smeared after the vehicle has been cleaned in a
car wash.
X
Clean the windshield (
There is windshield chip damage in the camera's field of vision.
X
Replace the windshield.
The windshield is fogged up on the inside.
X
The windshield is iced up.
X
There is dirt on the inside of the windshield.
X
Clean the inside of the windshield (
Active Driving Assistance package
The Active Driving Assistance package
consists of DISTRONIC PLUS (
Active Blind Spot Assist (
Active Lane Keeping Assist (
Important safety notes
Active Blind Spot Assist uses a radar sensor
system to monitor the side areas of your
vehicle which are in back of the driver. A
warning display in the exterior mirrors draws
your attention to vehicles detected in the
monitored area. If you then switch on the
corresponding turn signal to change lane, you
will also receive an optical and audible
collision warning. If a risk of lateral collision
is detected, corrective braking may help you
avoid a collision. To support the course-
correcting brake application, Active Blind
Spot Assist also uses the forward-facing radar
sensor system. Active Blind Spot Assist
supports you from speeds of approximately
20 mph (30 km/h).
Active Blind Spot Assist is only an aid, and
may detect vehicles/obstacles incorrectly or
not at all.
The system may be impaired or may not
function if:
R
there is poor visibility, e.g. due to snow,
rain, fog or spray.
R
the rear and/or front sensors are dirty.
Active Blind Spot Assist may not detect
narrow vehicles, such as motorcycles or
bicycles, or may only detect them too late. It
cannot detect vehicles that are overtaken at
a small distance and then enter the blind spot
area.
Active Blind Spot Assist cannot detect road
and traffic conditions. It is not a substitute for
Driving systems
321
Driving and parking
Z
Summary of Contents for CL2012
