TS790+ & TS900+ Installation Manual
Appendices
57
The TS790+/900+ is very flexible in the way that
the system can be part-set. The system may be
part-set by using the part-set buttons on the
remote keypad or by using a part-set
passcode.
The first application example shows how to use
the part-set buttons to set different areas of a 3
bedroom house. The second example will show
how to achieve the same results using a
different approach. Try both and use the one
you are happier with.
Defining Part-Set buttons to Omit a Ward
This is probably the easier method of
configuring the part-set groups as you can
easily take the information from a table and
translate it directly into the ward programming
details.
Using the drawing of a typical 3 bedroom
house, the following part-set arrangements are
required:
Part Set A
Downstairs perimeter detection
armed and downstairs internal
detection armed.
Part Set B
Downstairs perimeter detection
armed, downstairs internal
detection armed and bedroom
2 armed.
Part Set C
Downstairs perimeter detection
armed.
1. First create a table listing the circuits that are
required to be Armed (A) and Omitted (O)
for each part-set requirement:
Circuit Location
P-Set A P-Set B P-Set C
01
Front Door
A
A
A
02
Smoke Detector
A
A
A
03
Hall door to garage A
A
A
04
Garage door
A
A
A
05
Garage back door A
A
A
06
Kitchen door
A
A
A
07
Dinning room PIR
A
A
O
08
Lounge PIR
A
A
O
09
Bedroom 2 PIR
O
A
O
10
Landing PIR
O
O
O
2. From the above Table create a second
Table that details the ward assignment for
each circuit. The rules for generating the
second table are as follows:
(a) Circuits that are armed in all three part
set groups can be considered as being
assigned to the “System Ward” and are
NOT assigned to wards A, B or C.
(b) Circuits that are omitted are assigned to
their respective ward, e.g., circuit 09 is
omitted for part set A and C, therefore it
must be assigned to wards A and C.
3. The completed Table should look like the
table shown below. Circuits with no ticks are
assigned to the System Ward:
Circuit Location
Ward A Ward B
Ward C
01
Front Door
02
Smoke Detector
03
Hall door to garage
04
Garage door
05
Garage back door
06
Kitchen door
07
Dinning room PIR
4
08
Lounge PIR
4
09
Bedroom 2 PIR
4
4
10
Landing PIR
4
4
4
4. From the above Table assign circuits 01-10
to their relevant wards
(see “Configure
Wards” on page 41).
5. Program the Part set groups
(see “Part set
Groups”, on page 47
). This ensures that
when the user selects button A, B or C the
system omits the correct ward. When using
this method, the part set groups
MUST
be
programmed as follows:
Part Set Group A = [S BC] (Omits Ward A)
Part Set Group B = [SA C] (Omits Ward B)
Part Set Group C = [SAB ] (Omits Ward C)
¨
When defining part set groups it is
important to remember that circuits
assigned to more than one ward will
only be armed when
all
the wards its
assigned to are set. e.g., the Landing
PIR will only be armed when ward A, B
and C are set (i.e., Full set in our
example).
