Installing Modules
Rev A04
Mellanox Technologies
66
Figure 40: Securing the sMBE Board
5.3.6 Extracting a Management Board (sMBE)
To extract a sMBE from the chassis:
1. Disconnect CLI and I2C cables from the specific board.
2. Release the security screws.
3. Press the red tabs to unlock the ejectors.
4. Wait for the Blue Hot Swap LED to light.
5. Press the ejectors outwards and slowly slide out the board.
•
The sMBE cannot operate properly unless the clips are fully locked. Press them
inwards until you hear them click.
•
When using a drill-like electric screwdriver to fasten the board screws in place, do
not use more than Torque 2 force (10 lb. in) as this could damage the screws.
