Rev A04
Mellanox Technologies
53
Figure 29: Grounding Stud Installation
2. Add a spring washer onto the 10-32 5/8" thread, this time from the front to the rear.
3. Add a #10 nut.
4. Add another spring washer.
5. Insert the 10 AWG grounding cable, and then connect its other end to a grounding point.
6. Add another spring washer. Make sure that the grounding cable is tightly secured between the
two spring washers.
7. Secure everything with a grounding nut #10.
8. Attach the Ground Notice label under the grounding nut.
9. Attach the Safety Warning label on the side of the chassis, near the grounding stud.
4.1.2 Mounting the Chassis in the Rack
This section explains how to mount the Vantage 8500 switch in a 19" rack.
Screws and clip nuts to connect the chassis to the rack and rail kit to rack are not
supplied.
