Meler Micron 5, Instruction Manual

Page: 22 / 118

FOCKE MELER GLUING SOLUTIONS
2-8
INTRODUCTION
Gas injection option
There is the possibility of preparing the equipment with an air or gas input
into the reservoir. This entrance is done from the top and the equipment is
prepared from the factory.
Air dryer system
The air dryer system must be requested separately and is the same for the 5,
10, 20 and 35l machines.
Bypass valve pressure control system
Pressure control can be effected through pneumatic or mechanical regulation.
By default, the equipment is fitted with pneumatically regulated pressure
control.
Level control system
To detect a low level of melted adhesive, there is a choice between capacitive
or float level detectors. Either can be used with any of our equipment,
although if the detector is ordered after the equipment is delivered you may
only use the float detector; the capacitive detector requires a housing inside
the tank that must be made by machine.
Warning light option
The warning light must be requested separately. There is a choice of the low
level and colourless (white) indicator light or the low level and temperature OK
indicator light (green). They are both the same for all machines.
Optional equipment
To increase the functionality of the melter machines, the following optional
elements can be incorporated:
• Wheels: these can be fitted to all the machines.