Meler Micron + 10, Instruction Manual, Page: 23 / 120

MA-5162-ENG PISTON ADHESIVE MELTER INSTALLATION
3-1
3. INSTALLATION
Warning: The melters/applicators are equipments with current technology
and with certain foreseeable risks. Therefore, only allow qualified personnel
with sufficient training and experience to use, install or repair this equipment.
Introduction
The ‘’ series melters/applicators are delivered with all the materials
necessary for their installation. However, some components must be provided
by the user himself, according to the location and connections in each
particular installation:
• Anchoring screws for the melter/applicator equipment
• Power cord and plug for electrical power
• Pneumatic pipe and connection to the compressed air system
• Multicore cable for external electrical control
• Optionally, a gas ventilation system
Installation requirements
Before installing ‘’ series melter/applicator equipment, we must
make sure that the space assigned to it permits installing, connecting and
using the entire system. Similarly, we must check to see that the electrical
and pneumatic supplies meet the necessary requirements of the melter/
applicator equipment being installed.
Free space
E
A
C
D
B