![background image](http://html1.mh-extra.com/html/meler/cantho/cantho_instruction-manual_1767116029.webp)
MELTER OPERATION
4-5
MA-5168-ENG
ADHESIVE MELTER CANTHO
Temperature adjustment
The melters/applicators leave the factory with the following set point
temperature values:
• 160 °C (320 °F) for the tank and manifold
• °C displayed
• Overheating value: 20°C
• Standby value: 40%
• Delay time: 10 min
• On/off and stanby programming: ON
The general process for adjusting the temperatures of each components is
described below.
1. Select the component whose value you wish to modify using the up-
down arrow for element selection.
The corresponding LED will blink rapidly.
2. Select the desired set point temperature value with the up-down
arrow under the display. Below 40°C the set point value displays ‘OFF’
canceling the heating of that element.
3. After ten seconds, the LED will stop blinking and the display will show
the tank’s set point temperature value by default, saving the modified
data.
This simple procedure should be repeated for each of the components whose
set point temperature value you wish to modify.
Programming the applicator parameters
The access to the parameters is performed from the special menu. Simulta-
neously press the buttons with the clock symbol and the down arrow to enter
this menu.
The navigation order is as follows:
160
160 160
160
11
22
Function
Symbol on the
display
Default value
Selects the temperature unit to display
ºC
Programs overheating
20 ºC
Programs the temperature for the STANDBY mode
40%
Delay time to activate of signa temp OK and main machine
t
10 minutes
160
160 160
160
Summary of Contents for Cantho
