Meler Cantho, Instruction Manual

Page: 27 / 66

MELTER OPERATION
4-3
MA-5168-ENG ADHESIVE MELTER CANTHO
They are also equipped with LEDs indicating equipment connection/
disconnection and standby function connection/disconnection (3).
Displaying the temperature for each component
The temperature may be displayed for each component (grille and tank) by
selecting the component with the cursor.
Press the uo-down arrow until the desired component is displayed.
After 10 seconds, the display will return to the default component (the grille)
If you wish to keep the component displayed permanently, press and hold the
up-down arrow for 2 seconds while selecting the chosen element.
Alarm displays
The melter equipments tell the user when a malfunction has occurred in
the unit, sending warning messages that may be seen on the control panel
display.
When an alarm appears, the control unit takes a series of steps to protect the
unit. Simply correct that malfunction and the control unit will reactivate the
equipment functions.
Standby function does not generate any alarm.
If a temperature sensor is broken, the system heats all the elements except
the one where the failure is located.
160 160 160 160
Err Err 001 001
LED display Component heating Component staus
constantly lit constant low temperature
blinking slowly as need (acoording to PID parameters) temperature near set point
blinking rapidly programming or display change in set point values
off not heating temperature reached
LED display On/off Standby
constantly lit turned off unit function activated
blinking slowly
descativation programmed for the
current day
activation programmed for the
current day
blinking rapidly
activation/desactivation programming
mode
activation/desactivation program-
ming mode
off unit in operation function desactivated
simultaneous intermittence from leds of
pump activation and main machine signal timing in process, once the tank has reached its set point temperature
160 160 160 160
3