![background image](http://html1.mh-extra.com/html/meler/cantho/cantho_instruction-manual_1767116012.webp)
FOCKE MELER GLUING SOLUTIONS
2-2
INTRODUCTION
Description
Operating modes
These melters can be used in the modes described below:
Operating mode_
The melter keeps the hot components at the
temperature indicated on the display, which has been preselected as the
desired value. The system continues to wait for the signal to start the
piston pressure and to open the discharge valve to the unit’s roller tank.
1.
Work mode with piston cylinder
Manual mode_
It does not depend on the low level signal from
the roller tank sensor. The discharge process will be carried
out providing that this operating mode is selected with the
corresponding switch (MAN position) and providing that the
piston has been activated using the corresponding selector
(down), with the discharge valve being activated at the same
time. The discharge process will stop if the operating mode
switch is placed in position ‘0’ or the piston switch is placed in
the ‘0’ or ‘up’ position.
Automatic mode_
If a low level is detected in the roller tank, the
piston and the discharge valve will be lowered and will remain
in this status until the level of adhesive detected by the sensor
is reached. At this point, the signal to lower the piston will be
deactivated and the discharge valve will close. This cycle will
repeat until the piston switch is moved to the ‘0’ or ‘up’ position,
or you exit automatic mode by placing the operating mode switch
in the ‘0’ position.
2.
Work mode without piston cylinder
Manual mode_
It does not depend on the low level signal from
the roller tank sensor. The discharge process will be carried
out providing that this operating mode is selected with the
corresponding switch (MAN position) , with the discharge valve
being activated at the same time. The discharge process will
stop if the operating mode switch is placed in position ‘0’.
Standby modes_
The melter remains in standby mode with the
temperatures of the components at a (programmable) value that is
below the preselected value.
Warning/alarm mode_
The melter detects a malfunction and alerts the
operator. According to the type of issue, the system will either continue
to operate or will stop until the incident has been resolved.
Stop mode_
The melter remains off without heating the components.
However, the unit is still supplied with electrical power and
pneumatic air.
Hot-melt melter/applicator identification
When placing orders for replacement parts or requesting help from our
service center, you should know the model and reference number of your hot-
melt melter/applicator.
This and other technical information will be found on the identification plate
located on the side of the lower part of the hot-melt melter/applicator.
2
1
Con cilindro
empujador
Sin cilindro
empujador
Selector de modo
Selector de modo
Selector de pistón
Summary of Contents for Cantho
