Meler Cantho, Instruction Manual

Page: 28 / 66

FOCKE MELER GLUING SOLUTIONS
4-4
MELTER OPERATION
In case of overheating the system cuts off inmediately the damaged element.
After three minutes if the failure continues all the system will be shut down.
After repairing the failure the system starts heating normally.
Operational pressure display and adjustment
In these equipments the air pressure with which the pneumatic control of
the pusher piston cylinder device works with is shown on the pressure gauge
located on the base of the melter/applicator. The pressure must be adjusted
according to the application needs.
Warning :Never surpass 6 bar of pressure
To regulate the pressure, pull the handle out and turn the regulator clockwise
(+) or counterclockwise (-) as needed.
+ - + -
Code Source
Actions
Heating Temp. OK and Main machine signal
Err 0 Grille broken sensor only grille off off
Err 1 Tank broken sensor only grille off off
Err 100 Grille overheating all components off off
Err 101 Tank overheating all components off off