MediSono P11 EXP, User Manual

Page: 124 / 151

P11 EXP
Portable Digital Color Doppler Ultrasound System
12-4
F5
SET
MOVE U-D
Press to select MOVE U-D , turn the function knob to move the 3D structure display
in the up/down direction.
12.3.3 Auto Rotate
AUTO ROTATE
Turn on this function to activate the auto-rotation of the display of the 3D structure. This
function is normally used for demonstration purpose.
The maximum angle of rotation can be set to
45°, 90°, 180°, 270° or 360°.
The display of
the 3D structure rotates continuously (first clockwise and then counterclockwise) from
0°
to
this maximum angle.
12.3.4 Render Mode
RENDER MODE
Three render modes are available: Volume Rendering (Vol), X-ray, Maximum Intensity
Projection (MaxIP).
Vol Mode: displays the contour of the internal organs or fetus.
MaxIP Mode: displays the samples with the highest intensity along the ultrasound beam.
X-ray Mode: displays the average gray values of the echoes along the ultrasound beam.
12.3.5 Trace Cut
TRACE CUT
Turn this function on to remove any unwanted region from the volume display. Practically, it
can be useful for clearing region obstructing the display of ROI.
To use Trace Cut:
• Select
TRACE CUT in the menu and press
• Press the arrow keys to set the value to
In
.
• Use the trackball to draw a trace on the volume image.
• Press
to close the trace and hide the region inside the trace.
• To hide the region outside the trace, set
Trace Cut to
Out
and repeat the above steps.
✖
Note:
To unhide the region removed by
Trace Cut
, tap
Undo Cut
.
UNDO CUT
This function restores the display of the volume removed by TRACE CUT .
12.3.6 Clip Plane
CLIP PLANE
Turn this function on to enable the clipping plane. The clipping plane cuts through the 3D
structure and shows the section view.
To move the position of the clip plane:
1. Move the cursor over the volume display and press
UPDATE
or
2. Use the trackball to move the clip plane position.
SET
.
ZOOM
.