10
Programming device codes
For every device that you would like to operate using the universal
remote control, you must program a three-digit device code to a
source key (
TV, VCR, DVD, CD, CBL, ASAT, DSAT, AUX
) . The names
on the keys are only for reminder purposes. You can assign any key
to any device (“Flex Mode”).
For combined devices (e.g. TV set with video recorder, TV set with
DVD player, DVD and video recorder) it is often necessary to assign
two source keys with the respective code for each part of the device.
However, there are also combined devices with only one code for
both device parts (see also “Operating combined devices”, page 16).
Entering the device code according to the Code
List
The codes of the corresponding devices can be found in the Code
List enclosed with these operating instructions. Proceed as follows:
1. Switch the relevant device on manually.
2. Keep the
S (SETUP)
key pressed down for approx. 3 seconds, the
background lighting of the source key will flash for a short time
and then remain permanently lit.
1
(Briefly pressing the SETUP
key will activate the SHIFT function.)
3. Briefly press the desired source key (
TV, VCR, DVD, CD, CBL,
ASAT, DSAT, AUX
)
2
.
4. Enter the three-digit code from the Code Table.
The background lighting will extinguish briefly each time the key
is pressed.
1. Only the source key that was actuated last will light up. During
first use, the TV key will light up.
2. The names above the keys are only for reminder purposes. You
can assign any key to any device (“Flex Mode”).
Univ-FB_MD80383_AUS.fm Seite 10 Dienstag, 24. Januar 2006 8:57 08
