12
Automatic search
If your device does not respond to the remote control even though
you have tried all of the codes listed for your device type and the
relevant brand, then try using the automatic search. This will enable
you to find codes for brands that were not listed in the device Code
List.
1. Switch the relevant device on manually.
2. Keep the
S (SETUP)
key pressed down for approx. 3 seconds, the
background lighting of the source key will flash for a short time
and then remain permanently lit. (Briefly pressing the SETUP key
will activate the SHIFT function.)
3. Briefly press the desired source key (
TV, VCR, DVD, CD, CBL,
ASAT, DSAT, AUX)
.
4. Point the remote control at the device and briefly press the
PROG+ key once. If the device does not have a program func-
tion, then instead of pressing
PROG+
press the
PLAY
key or
.
The remote control will begin the code search after 6 seconds
and will transmit all codes consecutively at one-second intervals
(see also the next section). The source key will light up for each
transmission.
5. As soon as the device responds to the remote control, press
OK
with the joystick. – If you missed pressing
OK
on time, you can
go back by steps to the code to which the device responded by
using the
PROG–
key.
To cancel the search, press
EXIT
.
1 second or 3 second intervals
If you want the remote control to transmit a new code every 3
seconds instead of every second, proceed as follows:
Within 6 seconds of pressing the PROG+ key (or
PLAY
or
) as
described in Point 4, press the
PROG+
or
PROG–
key again. The
remote control will now only transmit a new code every 3 seconds.
This gives you more time, but the procedure will also take longer.
Univ-FB_MD80383_AUS.fm Seite 12 Dienstag, 24. Januar 2006 8:57 08
