mecalac AS 50, Operating Instructions Manual

Page: 65 / 114

S050/S051/Z050 8-5
Maintenance 8
8.2.3 Checking the oil level in the distribu-
tion gear
(1) Unscrew the plug (8-4/arrow) from the transmission
housing.
N O T E
- The oil level must reach the plug bore.
- Collect any escaping oil.
(2) Replace the plug.
8.2.4 Checking the oil level in the hydraulic
oil reservoir
(1) Park the loader in a level position.
(2) Place the bucket arm in its lowest position and tip the
quick-change device.
(3) Open the motor cover.
(4) Check the oil level in the sight gauge.
N O T E
The oil level must be visible in the sight gauge (8-5/arrow).
If necessary, fill oil into the filler neck (8-15/arrow).
8.2.5 Changing the engine oil
N O T E
The oil drain plug is accessible from below and is located
on the engine front (as seen in travelling direction).
(1) Place a sufficiently large oil drain pan underneath the
motor oil sump.
(2) Unscrew the cover for access to the oil drain on the
motor (8-6/arrow).
(3) Screw the drainage nozzle with hose from the tool box
(4-1/10) to the oil drain.
(4) Remove the cover cap from the hose.
(5) Further procedures can be found in the Engine Opera-
ting Manual.
Figure 8-4
Figure 8-6
Figure 8-5