mecalac AS 50, Operating Instructions Manual

Page: 11 / 114

S45E/S45T/Z45T 1-3
Safety regulations 1
1.3.2 In addition to the operating manual (machine and
engine) the general applicable and other binding regula-
tions for the prevention of accidents (especially the safety
regulations of the German Trade Association - VBG 40) as
well as the regulations for environment protection must be
observed and the personnel must be accordingly instructed.
Traffic regulations must also be observed.
1.3.3 The personnel in charge of working with the
machine must read the operating manual (machine and
engine) before start of work, especially the chapter
concerning safety precautions.
This also applies to personnel working occasionally with
the machine, e.g. during maintenance work.
1.3.4 The driver must wear a seat belt during operation.
1.3.5 Personnel working with the machine must not
wear long flowing hair, loose clothing or jewelry including
rings as this could cause injuries by getting caught up or
pulled in by the machine.
1.3.6 All safety and danger plates on the machine must
be observed.
1.3.7 All safety and danger plates must be attached to
the machine and must be kept in legible condition.
1.3.8 In case of modifications to the machine, especially
in case of damages or changes in the operating behavior
of the machine which could influence the safety of the
machine, stop the machine immediately and inform the
competent person in charge about the incident.
1.3.9 Without the manufacturer’s consent, do not make
any modifications or conversions to the machine which
could affect safety. This also applies to the installation and
adjustment of safety devices, valves and welding work to
supporting parts.
1.3.10 Check hydraulic system, especially hydraulic
pipes, at regular intervals for defects. Immediately eliminate
any defects found.
1.3.11 The prescribed inspection periods set down in the
operating manual (machine and engine) and the mainte-
nance plan must be observed.
1.4 Selection of personnel and necessary
qualifications
Fundamental obligations
1.4.1 The machine may only be driven and maintained
by personnel selected by the employer for this purpose.