mecalac AS 50, Operating Instructions Manual

Page: 50 / 114

S45E/S45T/Z45T 6-2
6 Attachments
6 Attachments
6.1 Mounting and dismounting
attachments without hydraulic connections
6.1.1 Standard/lightweight bucket
Mounting
(1) Bring the bucket to its lowest position and tip the
quick-change device.
(2) Drive the loader up to the bucket (6-1).
(3) Pick up the bucket using the quick-change device
and, by simultaneously tilting the quick-change device,
raise the bucket until the quick-change device is next to it
(6-2).
(4) Lock the bucket (6-3) by using the hand lever of the
auxiliary hydraulic system (4-7/16).
(5) Check the connection and the lock on both sides.
DANGER
Both bolts of the quick-change device must fit in the
boreholes of the bucket support and must be clearly visible
(6-3/arrow).
Dismounting
(1) Place the bucket firmly on the ground.
(2) Press the release button for the quick-change device
(4-8/2) and, while keeping the button depressed, unlock
the bucket by using the hand lever for the auxiliary
hydraulics (4-7/16).
CAUTION
The hydraulic quick-change device must only be locked
when an attachment has been mounted.
(3) Tilt the quick-change device and reverse out.
N O T E
The type label is on the rear of the bucket, on the right below
the cross arm.
Figure 6-1
Figure 6-3
Figure 6-2