Page 71
Speed Level Seres - Servce & Parts Manual
January 2019
Secton 6 - Electrcal System
completed.
Press ENTER when “NO” is displayed if there is no need to redo the EMPTY phase.
Press UP or DOWN to display “YES” then press ENTER if it is necessary to redo the EMPTY
phase.
If the previous EMPTY calibration was in error, or if the pressure sensor is replaced, it will be
necessary to redo the EMPTY phase.
REDO LOADED:
This message is displayed if the LOADED phase of load calibration has previously been
completed.
Press ENTER when “NO” is displayed if there is no need to redo the LOADED phase.
Press UP or DOWN to display “YES” then press ENTER if it is necessary to redo the LOADED
phase.
If the previous LOADED calibration was in error, or if the pressure sensor is replaced, it will be
necessary to redo the LOADED phase.
TOTAL DATA:
This message is displayed at the end of each phase, to confirm the number of measurements
recorded by the GP400. No operator input is required during this process.
•
•
•
•
•
•
•
•
