Page 321
Speed Level Seres - Servce & Parts Manual
January 2019
Decals, ES Models, CE Specification - Part 1
ART_3398
Decals
Sigma Level
CE Speed Level
™
ES Models: Sheet 1 of 4
2684
INSPECT MACHINE AND MAKE SURE THAT IT IS OPERATING PROPERLY,
THAT ALL NAME PLATE AND SAFETY AND CONTROL DECALS ARE IN PLACE
AND LEGIBLE, AND THAT THE MACHINE IS IN ACCORDANCE WITH THE
MANUFACTURER'S MAINTENANCE REQUIREMENTS CONTAINED IN THE
OPERATION AND MAINTENANCE MANUAL AND THE DAILY SAFETY CHECKLIST.
OPERATE MACHINE WITH EXTREME CAUTION. WATCH FOR OBSTRUCTIONS
WHICH MAY STRIKE PLATFORM, PERSONNEL, CONTROLS, OR MACHINE.
OPERATE CONTROLS SLOWLY FOR SMOOTH PLATFORM MOTION.
FOR DRIVING WITH PLATFORM LOWERED:
FOR DRIVING WITH PLATFORM ELEVATED:
DRIVE ONLY ON A SMOOTH, FIRM, AND PLANAR
SURFACE FREE OF OBSTRUCTIONS.
DO NOT EXCEED MAXIMUM PLATFORM OR
EXTENSION LOAD LIMIT CAPACITY.
LOAD TO BE UNIFORMLY DISTRIBUTED.
PLACE LOAD NEAR CENTER OF PLATFORM
WHEN POSSIBLE.
DO NOT DRIVE ON SIDE SLOPE IF PLATFORM
IS OVER 5% OFF LEVEL.
DO NOT DRIVE UP OR DOWN A GRADE OF
OVER 40%.
DO NOT EXCEED MAXIMUM PLATFORM OR
EXTENSION LOAD CAPACITY.
LOAD MUST BE UNIFORMLY DISTRIBUTED.
IF TILT WARNING LIGHT ILLUMINATES OR
TILT ALARM SOUNDS LOWER PLATFORM
AND RE-LEVEL
USE EXTREME CAUTION.
OTHER HAZARDS
IMPROPER OPERATION OF THIS MACHINE
COULD CAUSE DEATH OR SERIOUS INJURY.
1. DO NOT EXCEED PLATFORM LOAD CAPACITY.
2. DO NOT EXCEED MAXIMUM SIDE FORCE AND
MAXIMUM NUMBER OF OCCUPANTS.
3. DO NOT USE WITHOUT GUARD RAILS IN PLACE,
AND ENTRY GATE PROPERLY SECURED.
4. DO NOT USE IF WORK PLATFORM IS NOT WORKING
PROPERLY OR IF ANY PART IS DAMAGED OR WORN.
5. DO NOT USE NEAR MOVING VEHICLES OR CRANES.
6. DO NOT STAND OR SIT ON GUARDRAILS,
ALL PERSONNEL SHALL ALWAYS MAINTAIN FIRM
FOOTING ON PLATFORM FLOOR.
7. DO NOT USE WHILE UNDER THE INFLUENCE OF
ALCOHOL OR DRUGS.
8. DO NOT OVERRIDE SAFETY DEVICES.
9. DO NOT LEAVE MACHINE UNATTENDED WITH KEY
IN THE SWITCH.
10. DO NOT RAISE PLATFORM WHILE MACHINE IS ON
A TRUCK, FORKLIFT, OR OTHER DEVICE OR VEHICLE.
11. DO NOT USE LADDER, SCAFFOLDING, OR OTHER
DEVICES TO INCREASE SIZE OR WORKING HEIGHT
OF PLATFORM.
12. DO NOT ENTER OR EXIT PLATFORM WHILE IN MOTION.
13. DO NOT RECHARGE BATTERIES NEAR
SPARKS OR OPEN FLAME, BATTERIES EMIT
HIGHLY EXPLOSIVE HYDROGEN GAS.
14. DO NOT PERFORM SERVICE ON THE MACHINE WITHOUT
PROPERLY SUPPORTING ELEVATING ASSEMBLY.
15. DO NOT ATTACH OVERHANGING LOADS OR
INCREASE PLATFORM SIZE.
91846
7
TIP-OVER HAZARDS
YOU MUST NOT OPERATE
THIS MACHINE:
DO NOT DRIVE NEAR DROP-OFFS,
HOLES, OPEN ELEVATOR SHAFTS,
AND LOADING DOCKS
DO NOT ELEVATE PLATFORM ON
UNEVEN OR SOFT SURFACES
DO NOT DRIVE ONTO UNEVEN OR
SOFT SURFACES WHEN ELEVATED
DO NOT RAISE PLATFORM IN
WINDY OR GUSTY CONDITIONS
DEATH OR SERIOUS INJURY
WILL RESULT FROM IMPROPER
USE OF THIS EQUIPMENT
DEATH OR SERIOUS INJURY
WILL RESULT FROM CONTACT
OR INADEQUATE CLEARANCE
91845
ELECTROCUTION HAZARD
THIS MACHINE IS NOT INSULATED
UNLESS YOU HAVE BEEN AUTHORIZED TO
USE AND TRAINED IN THE SAFE OPERATION
OF THIS MACHINE.
TRAINING INCLUDES COMPLETE KNOWLEDGE OF
THE SAFETY AND OPERATION INSTRUCTIONS
CONTAINED IN THE MANUFACTURERS MANUAL,
ANSI MANUAL OF RESPONSIBILITIES,YOUR
EMPLOYERS WORK RULES AND APPLICABLE
GOVERNMENTAL REGULATIONS.
AN UNAUTHORIZED AND UNTRAINED OPERATOR
SUBJECTS THEMSELF AND OTHERS TO
DEATH OR SERIOUS INJURY.
MAINTAIN SAFE CLEARANCE FROM ELECTRICAL
LINES AND APPARATUS.YOU MUST ALLOW FOR
MACHINE SWAY, ROCK OR SAG AND ELECTRICAL
LINES SWAYING.
THIS MACHINE DOES NOT PROVIDE PROTECTION
FROM CONTACT WITH OR PROXIMITY TO AN
ELECTRICALLY CHARGED CONDUCTOR.
YOU MUST MAINTAIN A CLEARANCE OF AT
LEAST TEN (10) FEET BETWEEN ANY PART
OF THIS MACHINE OR ITS LOAD AND ANY
ELECTRICAL LINE OR APPARATUS CARRYING UP
TO 50,000 VOLTS. ONE FOOT OF ADDITIONAL
CLEARANCE IS REQUIRED FOR EVERY
ADDITIONAL 30,000 VOLTS OR LESS.
8
7156
16
14
18
91934
19
3084
WARNING
91944
MAXIMUM PLATFORM CAPACITY
EVENLY DISTRIBUTED
MAXIMUM
SIDE LOAD
400 N
680 kg
5-PERSONS
MAXIMUM
WIND SPEED
12.5 M/S
45 KM/H
12
1
6
5
LOCATE CONTROL BOX HERE
FOR NORMAL OPERATION OF THIS UNIT
7155
17
CERTIFIED LANYARD
8605
ANCHORAGE POINT
11
9
10
DISTANCE FROM GROUND TO LADDER WILL VARY WITH GROUND VARIATIONS.
CHECK DISTANCE BEFORE LEAVING PLATFORM.
91849
13
91850
15
20
91932
ES MODELS - CE
2
2684ES
3084ES
Decals, ES Models, CE Specification - Part 1
Secton 18 - Decals, CE Models
