Appendix F Command Set Description
MX-2100/2104
Installation and Operation Manual
F-40
Commands
•
FRAME
- Displays the framing format of the KVF.6 module.
−
For KVF.6/E1/31 or KVF.6/E1/16 displays G.732N or G.732S.
−
For KVF.6/T1/24 or KVF.6/T1/12 displays SF(D4) or ESF.
•
SIG_MODE
- Displays the signaling operation mode of the KVF.6 module:
CAS or CCS.
•
TS
- Displays the time slot number which carries the CCS information in the
KVF.6 module, only if SIG_MODE is CSS. IF SIG_MODE is CAS, the N/A will
be displayed in this field.
•
A,B,C,D
- Displays the information that will be sent through this bit to the PBX.
The options are: A, B, C, D, NOT_A, NOT_B, NOT_C, NOT_D, 0, or 1.
•
EXIST
- Indicates whether the module exists in the MX-2100 or not.
DSP SIGNALING
or
DSP SIG
Purpose
Display the signaling bits state in KVF.5 or KVF.6 modules.
Format
DSP SIGNALING {i}
or
DSP SIG {i}
Use
Displays the 4 CAS bits (A, B, C, D) of signaling for KVF.5 and KVF.6 modules for
connected time slots. For each card that carries CAS information (signaling mode is
CAS), all the connected timeslots will be displayed accompanied by their 4 CAS
bits current information.
DSP PRBS_INJ
Purpose
Display the result of the PRBS test running on the specified I/O module channel.
Format
DSP PRBS_INJ {i:j} [/C]
Use
Same as for the
DSP BERT
command, except the use of
PRBS_INJ
instead of
BERT
.
Note that if the PRBS test is activated without closing a loop along the
signal path, errors will always be reported.
