Black plate (190,1)
The sensitivity of the rain sensor can be
adjusted by turning the switch on the
wiper lever.
From the centre position (normal), rotate
the switch downward for higher
sensitivity (faster response) or rotate it
upward for less sensitivity (slower
response).
Hi
g
her sensitivity
Less sensitivity
Switch
Centre
position
CAUTION
l
Do not shade the rain sensor by
adhering a sticker or a label on the
windscreen. Otherwise the rain
sensor will not operate correctly.
CAUTION
l
When the wiper lever is in the
AUTO position and the ignition is
switched ON, the wipers may move
automatically in the following cases:
l
If the windscreen above the rain
sensor is touched or wiped with a
cloth.
l
If the windscreen is struck with a
hand or other object from either
outside or inside the vehicle.
Keep hands and scrapers clear of the
windscreen when the wiper lever is
in the AUTO position and the
ignition is switched ON as fingers
could be pinched or the wipers and
wiper blades damaged when the
wipers activate automatically.
If you are going to clean the
windscreen, be sure the wipers are
turned off completely
―
this is
particularly important when clearing
ice and snow
―
when it is most likely
that the engine is left running.
NOTE
l
Switching the auto-wiper lever from
the OFF to the AUTO position while
driving at a vehicle speed of 4 km/h
(2 mph) or higher (or after driving
the vehicle) activates the windscreen
wipers once, after which they operate
according to the rainfall amount.
l
The auto-wiper control may not
operate when the rain sensor
temperature is about _10 °C or
lower, or about 85 °C or higher.
5-60
Driving Your Mazda
Switches and Controls
Mazda5_8DF6-EI-13J_Edition7 Page190
Thursday, March 9 2017 8:35 PM
Form No.8DF6-EI-13J