Maxwell MW-3805 ST, Manual Instruction

Page: 13 / 44

13
ENGLISH
– For cooking of liquid milk porridges the recom-
mended proportion of rice and water has to be 1:3.
– Close the multicooker lid (5) until click.
– Insert the power cord connector (18) into the
socket (10) on the back side of the multicooker
body (1).
– Insert the power cord connector (18) into the
mains socket, you will hear a sound signal and
indication «
- - » will appear on the display (2).
AUTO-COOKING PROGRAMS
– To select an auto-cooking program press the cor-
responding button (22, 23, 24).
Note: - Cooking programs marked by green on the
control panel buttons (3) correspond to the green
light of the indicator, and programs marked by red
correspond to the red light of the indicator.
– When choosing one of the programs: «Boiling/
Roasting», «Stew/Steam cooking», «Porridge/
Baking» you may set the cooking time.
Consequently press the time setting buttons
«–»
(20) and «+» (21) to set the desired cooking time.
– Press the «Start/Stop» button (25) to switch the
chosen cooking program on, the indicator of the
button (25) will light up green. To stop the program
press the «Start/Stop» button (25) again, you will
hear a sound signal, the indicator of the operat-
ing program and the green indicator of the button
(25) will go out.
Note:
– Do not open the multicooker lid (5) in the «Baking»
cooking program before the cooking program is
finished.
– When the «Baking» program is finished, you need
to switch the «Keep warm» mode off by pressing
the «Start/Stop» (25) button so that the bakery
do not burn.
– The «Roasting» cooking program is similar to
cooking products on the kitchen cooker, so the
user must control readiness of products on his/her
own, you need to switch the multicooker off after
roasting the products.
– When the multicooker operates in the «Roasting»
program, the multicooker lid (5) must stay open
during the whole cooking process.
– Watch the products during cooking, stir the prod-
ucts with the plastic soup ladle (14) or spatula (16),
if needed. Do not use metal tools that can scratch
the non-stick coating of the bowl (4).
Attention! To avoid burns by hot steam or hot oil,
be very careful when opening the multicooker
lid (5), do not bend over the multicooker. Do not
open the multicooker lid too often.
– Upon termination of a cooking program you will
hear three sound signals, the multicooker will be
switched to the keep warm mode, the indicator of
the button (26) will light up red, duration time of the
keep warm mode will be shown on the display (2).
Note:
–
Despite the unit keeps the ready dish warm up
to 24 hours, it is not recommended to leave the
cooked food in the multicooker bowl for a long
time, because this may spoil the food.
– Do not use the keep warm function for heating up
the products.
– To switch the keep warm mode off, press the
«Start/Stop» button (25), you will hear a sound sig-
nal, the indicator of the button (26) will go out, and
the time on the display (2) will be reset.
To set the cooking end time
You can pre-set the time when the cooking process is
to be finished. This function is available in the following
programs: «Boiling» (22), «Stew/Steam cooking» (23),
«Porridge/Baking» (24).
– Time setting range: from 1 to 24 hours.
•
To set the cooking end time, select the necessary
cooking program using the buttons (22), (23) or
(24), the indicator of the corresponding mode will
start blinking.
•
Using the time setting buttons «−» (20) and «+» (21)
you may set the needed cooking time for the pre-
selected program.
•
Press the «Delayed start/Keep warm» button (26),
the digit «1» will appear on the display (2), the
indicator of the selected mode will light constant-
Program Program operation
duration (in minutes) Program time set by default
(in minutes) Cooking temperature,
о
с
«Boiling» 5 – 95 60 110-120
«Roasting» 5 – 95 20 130-140
«Stew» 5 – 95 40 90
«Steam cooking» 5 – 95 10 120-125
«Porridge» 5 – 95 30 95
«Baking» 5 – 95 40 130
MW-3805.indd 13 30.04.2013 15:02:57