Maxim Integrated MAX31782, User Manual

Page: 150 / 223

MaximIntegrated 17-15
MAX31782 User’s Guide
Revision 0; 8/11
17.3.5In-CircuitDebugBufferRegister(ICDB,M2[1Ch])
This register serves as the parallel holding buffer for the debug shift register of the TAP . Data is read from or written to
ICDB for serial communication between the debug routines and the external host .
r = read, s = special
17.3.4In-CircuitDebugFlagRegister(ICDF,M2[1Bh])
Bit 7 6 5 4 3 2 1 0
Name - - - - PSS1 PSS0 JTAG_SPE TXC
Reset 0 0 0 0 0 0 0 0
Access r r r r rw rw rw rw
Bit 7 6 5 4 3 2 1 0
Name ICDB .7 ICDB .6 ICDB .5 ICDB .4 ICDB .3 ICDB .2 ICDB .1 ICDB .0
Reset 0 0 0 0 0 0 0 0
Access rw rw rw rw rw rw rw rw
BIT NAME DESCRIPTION
7:4 Reserved Reserved . Do not write to these bits .
3:2 PSS[1:0]
Programming Source Select Bits [1:0] . These bits are used to select a programming interface during
In-System programming when JTAG_SPE is set to 1, otherwise, the logic values of these bits have no
meaning:
PSS1 PSS0 Interface/Action
0 0 JTAG
0 1 I2C
1 x Exit Loader
1 JTAG_SPE
System Program Enable . The JTAG_SPE bit is used for In-System programming support and its logical
state, when read by the CPU, always reflects the logical-OR of the JTAG_SPE bit that is write accessible
by the CPU and the SPE bit of the System Programming Buffer (SPB) Register in the TAP Module (which
is accessible via JTAG) . The logical state of this bit determines the program flow after a reset . When it is
set to logic 1, In-System programming will be executed by the Utility ROM . When it is cleared to 0, execu-
tion will be transferred to user code . This bit allows read/write access by the CPU and is cleared to 0 only
on a power-on reset or Test-Logic-Reset . The JTAG SPE bit will be cleared by hardware when the ROD
bit is set . CPU writes to the JTAG_SPE bit (0 or 1) will result in clearing of the PSS[1:0] bits .
0 TXC
Serial Transfer Complete . This bit is set by hardware at the end of a transfer cycle at the TAP commu-
nication link . The TXC bit helps the debug engine to recognize host requests, either command or data .
This bit is normally set by ROM code to signify or request the sending or receiving of data . The TXC bit
is cleared by the debug engine once set . CPU writes to the TXC bit results in clearing of the PSS[1:0]
bits .