3.0
MAINTENANCE
www.maxcessintl.com
MAGPOWR Spyder-Plus
MI 850A320 1 M
Page 9 of 60
The only maintenance that may be required on Spyder is fuse replacement. Replacement of the fuse requires
opening the enclosure, which circumvents the enclosure IP rating. To replace a fuse:
1. Disconnect the power supply.
2. Open the enclosure by inserting a flat blade screwdriver under the retaining tabs in the base. See Figure 3
3. Lift and rotate the cover being careful not to unplug the keyboard connector.
4. Replace the fuse with the recommended fuse type. (See Section 14.0, Specifications)
5. Re-install cover.
4.0
KEYPAD NAVIGATION
The use of the various keys is generally self explanatory.
The LEFT, RIGHT, UP, and DOWN arrow keys are used in menus to move to other screens.
The LEFT and RIGHT arrow keys are used to edit selection choices (e.g. to select system type).
In the tuning screens for dancer modes the UP and DOWN arrow keys are used to adjust the position of the
dancer. On these screens
appears in the bottom right hand corner of the screen, and the ENTER key is used to
exit the screen. (When the setpoint is Analog, the position setpoint input is not active during tuning.)
When a numeric screen is shown, the value may be edited by pressing the ENTER key to start editing. A numeric
edit screen will have a cursor under the digit being edited. The UP and DOWN arrows will increment and
decrement the digit, while the LEFT and RIGHT arrows will move the cursor. When finished editing the numeric
value, press the Enter key.
The DOWN arrow key will generally move to the next screen in a sub menu. For example, when the Configure
menu is displayed press the DOWN arrow key to scroll through System Type, Output Range, Setpoint Source,
Digital Input Active, Numeric Rate, Bar Graph Rate, and Contrast.
The UP arrow key usually returns to the previous screen.
