9.0
OPTIONAL FUNCTIONS
www.maxcessintl.com
MAGPOWR Spyder-Plus
MI 850A320 1 M
Page 33 of 60
9.1 PREFERENCES MENU
This section describes all the screens in the Preferences menu.
Navigate to the
Preferences
menu and Press
.
9.1.1
LANGUAGE
Select the language.
9.1.2
TENSION UNITS (Load cell systems and Dancer systems with Load Cells Enabled)
Select the Tension Units
9.1.3
DISTANCE UNITS (Load cell and Open Loop Tension systems only)
Select the Distance units.
9.2 TAPER TENSION SETUP
This section describes all the screens in the Taper menu.
Taper Tension is the reduction of tension as the diameter increases on
a rewind. Taper Tension is desired on rewinds to prevent crushed
cores and telescoping rolls caused by excess tension build up.
9.2.1 Taper with Load Cell Control
Diameter is estimated and must be calibrated to use taper tension.
Taper Percent, Section 6.2.1.3 must be set to "0" to calibrate taper.
Navigate to the
Taper Setup
menu and Press
.
Select "
Yes
" to enable Taper. Press
.
Enter the core diameter. The operator sets the setpoint tension only at
core. The tension at all diameters greater than core is less than the
Core Tension. Press
when finished.
Enter the diameter of the full roll. The Core Tension and Percent Taper
determine the tension at the full roll diameter. Press
when finished.
This screen actively displays the diameter as estimated by the Spyder
when in Run mode. Press
to calibrate taper.
Select “
Yes
” and press
to enter the Present Diameter. This screen
defaults to "
No
" and helps prevent accidentally overwriting a previous
calibration. Taper Percent, Section 6.2.1.3 must be set to "0" to
calibrate taper.
Enter the present diameter. This should be the present diameter of the
roll. The Spyder must be in Run mode. Press
to finish the
calibration.
