3-12
Masterflex REGLO Digital Pump Drive with Advanced Connectivity
Section 2: Basic Setup & Settings
Masterflex
To remove a Wi-Fi network:
1. Tap SETTINGS from any of the mode screens. The Settings screen will be displayed.
2. Tap WIFI SETTINGS. The WIFI Settings screen will be displayed.
3. Locate the desired Wi-Fi network and tap REMOVE WIFI .
4. Tap REMOVE to remove the network or CANCEL to discard changes.
5. Tap
CONFIRM
to return to the Settings screen.
Ethernet Settings
The REGLO can connect to a network using Wi-Fi and Ethernet connections.
NOTE:
• Confirm that the Ethernet cable is securely attached to the Ethernet port at the rear of the pump drive.
• The Ethernet connection will take priority if both Wi-Fi and Ethernet are used simultaneously.
To configure Ethernet settings:
1. Tap SETTINGS from any of the mode screens. The Settings screen will be displayed.
2. Tap ETHERNET SETTINGS. The Ethernet Settings screen will be displayed.
3. Tap DHCP to automatically configure IP settings or STATIC to manually edit settings using the onscreen
keypad.
4. Tap CONFIRM to save or CANCEL to discard changes.
Screen Saver
The REGLO has a screen saver to help extend the display life of the touchscreen. After 30 minutes of
inactivity the REGLO will enter sleep mode and the display will turn off. Tapping the touchscreen will
reactivate the drive.
To enable or disable the screen saver:
1. Tap SETTINGS from any of the mode screens. The Settings screen will be displayed.
2. Tap the SCREEN SAVER toggle to select either ON or OFF.
Display Brightness
To adjust the display brightness:
1. Tap SETTINGS from any of the mode screens. The Settings screen will be displayed.
2. SCROLL through the Settings screen pages to locate DISPLAY BRIGHTNESS.
3. Use the slider to adjust the touchscreen brightness to the desired level.
