Masterflex Ismatec Reglo 78018-10, Operating Manual

Page: 32 / 57

3-24 Masterflex REGLO Digital Pump Drive with Advanced Connectivity
Section 3: Operation
Masterflex
J. PRIME: Press and hold to prime the pump drive (for further information see " Priming the Pump Drive "
on page 3-7).
K. START/STOP/PAUSE: During operation, the display will change from START to PAUSE STOP/
RESET .
L. FLOW DIRECTION: Tap DIRECTION to select either clockwise or counterclockwise flow
direction.
M. SCREEN LOCK: Locking the screen disables all touchscreen functions. To lock the screen: Press and
hold UNLOCKED until the icon changes to LOCKED and a red border appears around the
screen. To unlock the screen: Press and hold LOCKED until the icon changes to UNLOCKED .
N. SETTINGS: Tap to access the Settings screen (for further information see " Settings " on page 3-10).
Volume Mode Edit Screen
Volume Dispense Mode Operation
General Preparation:
• Confirm the correct tubing has been selected and is properly loaded into the pump drive (for further
information see " Loading Tubing " on page 3-3).
• Confirm all fluids and containers are ready.
• Switch the drive on using the power switch located at the rear of the drive.
NOTE:
The touchscreen
display will revert to the previously used operation mode.
• Confirm that the tubing has been calibrated by checking that Calibration Complete is displayed on the
Volume Mode Edit screen (for further information see " Tube Calibration " on page 3-8).
Volume Record
Calibrate
Interval Time
Confirm
Batch Total
Mode Name Banner
Volume
Flow Rate
Tube Size
Anti-Drip
Tap to access the
Dispense Volume screen
Tap to return to
the previous screen
Tap to access the
Flow Rate Edit screen
Tap to access the
Tube Size screen
Tap to access the Anti-Drip screen
(see " Anti-Drip " on page 3-27)
Tap to access the
Interval Time screen
Tap to access the
Tube Calibration screen
Tap to access the
Batch Total screen
Tap to record fluid volumes (see
" Volume Record " on page 3-27)