Mastercook TG 5201ZSB, Instruction Manual

Page: 21 / 24

EN
20
Problem Solution
Gas burners fail to ignite Check to make sure the rubber hose supplying gas from the gas cylin - –
der is not squeezed.
Check to make sure the gas main valve is open. –
Check to make sure the gas cylinder is not empty. –
In case a new cooker has been installed or the gas cylinder has been –
replaced with a new one, then it is necessary to repeat the ignition
procedure until the gas reaches the burner.
Check to make sure the nozzle or burner flame holes are not clogged –
or flooded. If so, un-clog the nozzle hole using a pin or needle. Clean
the burner flame holes with the use of brush, and then dry all compo -
nents.
Flame dies after releasing the knob Your cooker is equipped with a flame failure safety device
Where the ignition device is activated by the button, set the knob to –
large flame and keep it pressed all the way in, press the ignition
button and when the gas has ignited keep the knob pressed all the
way in for another few seconds.
After setting the knob to simmering flame
position - the flame dies or is too high Avoid draughts in the kitchen, –
Call the fitter to adjust simmering flame position – .
Flame is unstable
Check to make sure that the burner components are clean, dry and –
placed correctly.
NOTE !
If after completing the above steps the appliance is still inoperative contact your local service centre.