Mastercook TG 5201ZSB, Instruction Manual

Page: 20 / 24

EN
19
9.1 General Tips
The cooker should be kept clean. The following •
may not be used for cleaning: abrasive powder cle -
aners, metal scouring pads, aggressive chemical
agents or sharp objects.
Stainless steel elements, knobs, dials and the con - •
trol panel should be cleaned with mild liquid deter -
gents containing no abrasive agents.
For enamelled parts use a soft brush or sponge •
moistened with warm water containing mild deter -
gents, avoiding excessive water. For heavily soiled
surfaces use kitchen-cleaning agents.
Do not clean glass surfaces using any abrasive •
agents or metal items, as they may scratch the sur -
face and cause the glass to break.
The hob surface around burners should always be •
clean as dirt deteriorates the combustion of gas.
When cleaning the hob do not allow water to get
beneath the hob.
Burners must be kept clean and dry to ensure their •
trouble-free operation.
Take the dirty grids off the gas hob, soak them in •
warm water with detergent and then wash and dry
them.
9.2 Cleaning the burners
NOTE !
Clean the burners, each time they become spilled
and also periodically remove blooms or dirt.
Elements of the burners (9.2.1)
1 – lid;
2 – ring;
3 – body;
4 – nozzle;
5 – thermocouple
To clean the burners remove the lid and the ring •
of the burners, put them in warm soapy water for
some time and then wash each part of the burner
separately
Clean the burner elements using a sponge or a soft •
brush and remove dirt from burner ports with a ste -
el wire. After cleaning check if the burner ports are
clear.
To avoid permanent stains, rings should be washed •
each time after they become soiled.
The hob surface around the burner should be kept •
clean at all times. Dirt may clog the nozzle, which
results in reduced gas flow or stoppage.
The nozzle should be cleaned with a small paint - •
brush dipped in a solvent.
Dry all the elements of the burners carefully as wet •
elements may not light or cause the gas to com -
bust improperly. Assemble clean and dry burners
carrying out the disassembling steps in the reverse
order.
In the warranty period all repairs except for the •
ones specified below should be carried out by the
authorised Servicing Point.
If there are some disturbances during the use of •
the appliance, follow the guidelines below to check
if you can repair the defect yourself.